HRS Construction
                         "Getting it Done Right"
 
Home Federal Tax Credit Specials Photo Gallery


LINKS
  Home
About Us
Customer Comments
FAQ
Product Information
Links
Contact Us
 
Facts
bullet

Are we insured?

Yes, HRS Construction, Inc. is covered by both General Liability and Workers Compensation Insurances.

bullet

Is HRS a member of the Better Business Bureau?

Yes. As of 6/8/10 HRS Construction, Inc. has an A+ BBB rating.

bullet What is Condensation?

Condensation comes from the moisture in the air, and is caused by too much moisture in the air for a certain temperature. Condensation forms when warm, moist air touches a surface that is colder than the dew point of the warm air. As that air becomes colder and its temperature drops below its dew point, it must release excess moisture to reach its new, lower dew point. It releases moisture in the form of water, which appears on the colder surface. (Harvey Industries)

bullet What to do if Condensation Appears on Your New Windows?

Your new Harvey Windows are designed to prevent air infiltration into and out of your home. Your old, drafty windows allowed the moisture in your home to escape (along with your heat)! Your new Harvey Windows are tight and do not allow the moisture in your home to escape. You need to control the humidity in your home.  (Harvey Industries)

bullet R-Value and U-Factor Information

R-Value is a measure of resistance to heat gain or loss. The higher the number, the better a product is at resisting heat loss.

U-Factor, the reciprocal of R-Value, is the measure of the rate of heat loss through a material. Thus, in all aspects of home design, one should strive for the lowest U-Factors possible because the lower the U-Factor, the less heat that is needlessly escaping.

bullet Terminology: Basic Install

Basic install is a term used as a baseline for installations such as replacement windows.

Replacement Window Basic Install

Remove interior stop, remove sashes. remove weight rope wheels, remove parting stop and remove storm windows.
Install replacement window unit.
Insulate perimeter of replacement window and caulk as needed.
Reinstall interior stop.
Remove debris from site.

Storm Door Basic Install

Remove existing storm door if any.
Install new storm door and hardware in existing door opening.
Remove debris from site.

bullet VSI

The Vinyl Siding Institute (VSI) is the trade association for manufacturers of vinyl siding and suppliers of raw materials, equipment and services to the vinyl siding industry. Reynolds's products are independently verified to meet or exceed ASTM D3679---the long-standing, accepted industry standard for quality vinyl siding products.

bullet

What is SHGC?

Solar Heat Gain Coefficient (SHGC) tells you how well the window blocks heat caused by sunlight. The lower the SHGC, the less solar heat the window transmits. SHGC is measured on a scale of 0 to 1; values typically range from 0.25 to 0.80.

Contact
bullet Contact Paul Sleasman by e-mail: PaulatHRS@nycap.rr.com, or call 518-426-4107 with questions about services that HRS offers.
 
 
 

Home | Federal Tax Credit | Specials | Photo Gallery

Copyright © 2006, HRS Construction, Inc..  All Rights Reserved.